Tillage and maintenance of tractors

November 12, 2024

First, before the tractor is officially used, it is necessary to conduct a comprehensive inspection. After the engine is started, it takes a period of time for the air to run until the water temperature of the engine and the oil temperature of the lubricating oil increase to the prescribed value before starting. At the start, the clutch must be completely disengaged, and then the shift lever should be hung up to the desired level, then the clutch should be slowly engaged, and the throttle should be gradually increased until the tractor begins to move and then the clutch is fully engaged.
2. Under normal circumstances, plowing should be done with 1 file when the plowing field is left, plowing with 2 plows when plowing for the second time, and 1 file for the first time, and 2 for the second time. File, use 3 files when you use the third pass. In this way, the load can be equal to the tilling power without damaging the parts. When the land is changed, hanging implements should be lifted and unilateral braking should be used. When crossing or crossing, use low gear and prohibit high-grade throttles from overtaking.
Third, after the tractor stops farming, it is necessary to timely clean and check whether there is any oil leakage, water leakage or air leakage. Fasten the engine seat, gearbox foot, front axle and drive wheel nuts, and adjust the tightness of the V-belt, check the brake and adjust to the best position. At the same time, it is necessary to add oil and lubricate the entire machine so that the locomotive is in good technical condition.
NINGBO MEDICAL EQUIPMENT CO.,LTD , https://www.techartmeds.com