Use and maintenance of rocking granulator
1. The rocking type granulator is a rocking action of a rotating drum. The wet powder material can be ground into particles by a wire sieve, and can also be widely used for pulverizing and becoming a ready-made granule. 1. Usage: Start the machine, pour the mixture into the bucket, and use the rocking action of the rotating drum to squeeze the material through the screen to form particles. If the crushing block is to be added gradually, it should not be filled up to avoid overpressure. Make the screen vulnerable. 1. Regularly inspect the machine parts once a month to check whether the worm gear, worm, bearing and other active parts are flexible and wearable. The defects should be repaired in time and should not be used barely. Anorectal Surgery Support,Sacrum Surgery Support,Operating Support Frame,Urology Surgery Accessories NINGBO TECHART MEDICAL EQUIPMENT CO.,LTD , https://www.techartmed.com Swing type particle machine use range
2. In the case of chemicals, the powder is used as a wet-laid powder, and after drying, it is used to compress the tablet, and it is also possible to pulverize the block which is agglomerated during storage or agglomerated during chemical processing. It is used industrially to treat confectionery and sugar blends and malt milk, and other industries such as ceramics, plastics and the like into shaped pellets.
3. It is not suitable for semi-solid, fluid, slurry or wear. Swing type particle machine use tips
2. Matters needing attention: If the powder does not stop in the powder bucket, it can not be used to shovel, so as not to cause injury, use bamboo shovel or stop work. Swing type particle machine maintenance instructions
2. The machine should be placed in a dry and clean room, and the atmosphere must not contain acids and other places where corrosive gases flow to the parts.
3. After the machine is used once or when it is stopped, the rotating drum should be taken out to clean or brush the remaining powder in the bucket, and then it is ready to be prepared for the next use.
4. If the deactivation time is long, the machine must be wiped clean. The smooth surface of the machine is coated with anti-rust oil and covered with a cloth.