Medicinal butterfly breeding and processing
HEBEI PINGLE FLOUR MACHINERY GROUP CO., LTD , http://www.plrollermill.com
First, aquaculture technology
1 Breeding houses: There must be windows on all sides of the house, skylights on the roof, and nylon gauze on the windows to prevent butterflies from fleeing.
2 The size of breeding houses depends on the scale of cultivation, and Umbelliferae plants are planted in the house for butterfly spawning and larval feeding.
3 feed: butterfly to eat pollen, sugar-based, in the home can put some sugar sponge, watermelon, melon and Ley, etc., can not be fed septic deteriorating moldy feed. In order to reduce the fatigue caused by flying too much of the female butterfly, it has an adverse effect on reproduction. During the day, the female butterfly can be placed in an open cardboard box and covered with a gauze. Sponge, sugar, water, melons, etc., will be released after spawning. In the rearing period, attention should be paid to the age of each insect and avoid direct sunlight for a long time.
4 To prevent injury, remove the natural enemies of the butterflies in the house, such as ants, mice, spiders, etc.
Second, larvae harvesting and medicinal
Four-day-old larvae can be harvested, and larvae are clearly visible on the leaves of the umbrella plants. When harvesting, the larvae were drunk with white spirits, and then dried on the tiles and dried as commercial fennel insects. Its sweet, pungent, warm, with warm cold, qi and relieve pain. According to reports, the isoxanthine component has been found in butterfly larvae of the Orthopodiidae and Pieridae families. The substance has a strong inhibitory effect on tumors. Can be used for lung cancer, breast cancer, acute leukemia and other treatments.
Third, the specimen processing to take fresh golden butterfly, according to its size to choose different specifications of the wing plate and different types of worms, inserted from the thoracodorsal back, leaving 8 mm in length. The specimens were inserted in the slats of the fins. The slivers were pressed and fixed with a pin. Using the same method, spread the front and back wings of the other side, align the corners, fix them with a pin, and dry them in a drying oven at 45°C. After about 9 hours, they can be removed. If there is no drying box, it can also be dried in a ventilated and dry room. It takes about 2 weeks.