Pikeron automatic shrink packaging machine guide
The automatic shrink packaging machine is a new revolution of the heat shrink packaging machine. It uses modern automatic technology, simpler operation, more stable performance and more efficient efficiency. It has become the latest heat shrinking machine on the market. . At the same time, the emergence of automatic shrink packaging machine has been well received by the industry, and is highly favored by the market! Pikeron automatic shrink packaging machine is a high-end packaging product. With the increasing number of users, consumers have insufficient understanding and understanding of this packaging equipment, and these shortcomings are often related to the user's correct operation. Whether or not. We all know that the incorrect operation will not only affect the life and work efficiency of the equipment, but also directly affect the efficiency of the enterprise. Below, we have the technical staff of the Peckron automatic shrink packaging machine to give us a detailed introduction to the use of the machine. The fully automatic shrink packaging machine is wrapped on the outside of the product by a shrink film. After heating, the shrink film shrinks and wraps the product, fully displaying the appearance of the article, thereby increasing the appearance and value. At the same time, it effectively protects the product from moisture, pollution and impact. The use of heat shrink packaging can also effectively reduce the cost of packaging products for enterprises, and bring more market competitiveness to enterprises. Precautions in the operation of automatic shrink packaging machine: Common automatic shrink packaging machine faults and troubleshooting: The above is the guide for the use of fully automatic shrink packaging machines and some common troubleshooting and troubleshooting methods. I hope that you will be better able to use the fully automatic shrink packaging machine in the future. Pikeron heat shrink packaging machine manufacturers will develop better equipment in the future to provide better service to customers!
1. The upper and lower heat chambers are divided into a set of fixed-open heat pipes and a temperature-adjustable electric heat pipe in the upper and lower chambers.
2. The temperature of the shrinkage chamber should be controlled below 230 °C, and the conveying speed should be controlled below 6-7. If it is over-temperature and over-speed, it will lead to premature aging of the circuit, the life of electrical components, and the service life of the machine will be reduced.
3. The bottom of the machine should be well ventilated and heat-dissipated to prevent overheating of electrical components.
4. The machine is used for more than three months to check the aging of the wire in the shrinking room and replace it as appropriate.
5. When the package passes through the studio, try to put it in the middle to avoid damaging the quartz tube.
1. There is no heating phenomenon in the shrinkage chamber or the heating temperature does not go up. Check whether the input power is normal, whether there is a lack of phase; the AC contactor is damaged or replaced; the temperature controller is out of order, repaired or exchanged; the indoor wire is aging and disconnected, the wire is exchanged; the electric heating tube is damaged and exchanged.
2. The drive motor does not turn. Check if the chain is too tight, loosen the bolts at both ends; the motor switch fails and exchanges; the speed control board is damaged and exchanged; the motor is damaged and exchanged.
3. The hot air motor does not turn. The fan is damaged and exchanged; the hot air switch is damaged and exchanged; the wind blade is stuck and removed after inspection.