Wheat Harvester Custody Four Preventions
Sodium Erythorbate,Sodium Erythorbate Powder,Food Additives Sodium Erythorbate,Antioxidant Sodium Erythorbate SHANDONG BAISHENG BIOTECHNOLOGY COM , https://www.baishengbioproducts.com
With the advancement of science and technology, wheat harvesting is gradually emerging from the sickle era. More and more peasant friends have used the wheat harvester for harvesting. Now is the wheat harvest season. I believe many farmers' friends have bought a new wheat harvester. However, many people do not care about the problem of parking after the use of wheat harvesters. In fact, damage to machinery during parking is often more than damage during work. In order to prolong the service life of the wheat harvester, the following “four preventions†must be done after decommissioning: 1. Anti-corrosion: Open the cover and shield on the harvester to thoroughly clean the dust, wheat straw, wheat straw, and miscellaneous dust on the machine. grass. Remove the external dirt, clean the crop residues in the working mechanism, and clean it with water or oil if necessary. Drive into the garage to release oil and cooling water. The new lubricant was dehydrated (heated to 110-150°C until the foam disappeared). Then crank the crankshaft a few times to fill the entire lubrication system. According to the lubrication chart, grease each spot with a grease gun to lubricate all parts of the wheat combine. Then use a plastic cloth to wrap the air filter, the vent nozzle, the tank cap, and the fuel tank cap. Remove the wooden axle bushes from the drive chain and the drafter. After the sludge is washed, dig out the sticky oil and put it in the engine oil and soak it in waterless oil for 20-30 minutes. Remove and wait until it sticks. The oil on the net drops, and then wrapped with kraft paper or plastic cloth, and stored in a ventilated and dry room. For all frictional surfaces, you must wipe off the oil after the application, preferably stickers, to reduce the chance of contact with the air. All parts that come in direct contact with the ground shall be supported by planks or bricks; the protective paint that has fallen off shall be recoated. 2, anti-aging: Remove all the belt (triangle belt), rubber or plastic products due to the oxygen in the air and sunlight in the ultraviolet light, aging and deterioration, so that the elasticity of rubber parts deteriorate and easy to break. After technical appraisal, you can still use it, wipe it clean, apply talcum powder, attach the label, and put it on the indoor shelf, cover it with paper, keep it ventilated, dry and free from direct sunlight. To hang on the wall, try to keep the belt from rolling. 3. Anti-deformation: Put the header on the harvester on the pre-prepared wood, lift the axle with the jack, support the cushion, and let the tire leave the ground. In order to reduce the inner tire pressure tire pressure, tire pressure should be put to 0.05 MPa. All springs that are pressed or pulled open on the machine must be loosened; parts that are removed, such as conveying pipes, must be prevented from accumulating, squeezing, and deforming during storage. 4. Loss prevention: Establish a registration card, detail the technical status of the equipment, attachments, spare parts, tools, etc.; prohibit disassembly of parts for other purposes; if there is no warehouse, when the equipment is parked outdoors, the motor, belt, etc. should be easily lost. Remove it and mark it. Store it indoors. The wheat harvester is only used for a certain period of the year and is still parked for most of the year. In order not to quietly turn your harvester into scrap, the above points must be noticed.